Cypress SPX-7200 Manual de usuario descargar pdf (Pagina 11)

Cypress Suprex® F.O. Series - Door Strike and LED I/O

The Cypress SPX-7400 provides additional data channels to support access control hardware such as door strikes,

tamper alarms, request to exit status, etc. These signals are sent to and from the Remote and Central units without

the need to run additional wiring."

The accessory control I/O use active low inputs. When the inputs are ﬂoating (nothing connected) the

associated output will be set to a high level. When the input is set to 0Volts (Ground) the input will

activate its associated output. All Accessory outputs are Open Collector type and will switch to Ground

when activated."

Each input will have an associated output. See the following pages for a diagram of each I/O pair.Inputs can be tested by

making a jumper connection to ground and monitoring the associated output.

Input

Jumper to ground to test

LED In

Suprex® Fiber Optic

Central

Ground

Suprex® Fiber Optic

Remote

Output

LED Out

Red arrow denotes direction of command signal

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17 18

Sin comentarios

Cypress SPX-7200 Manual de usuario Pagina 11