Cypress CWHDI-RX Especificaciones descargar pdf (Pagina 11)

7.2 Receiver

7.2.1 Front Panel

①

Link LED: When the system is in search mode the LED

will flash repeatedly and when the system is in

signal linking mode it will slowly flash. When the LED

is on and no longer flashing it means a connection

has been established and audio/ video can then

be sent.

②

Power button: Press this button to power up the

system, when the LED is lit the system has been

turned on.

③

IR Sensor

④

ID: Press this button along with Transmitters

“

”

button for two seconds to connect the systems.

Before they left the factory the systems were

already set up so there is no need for the user to

reset the connection unless the systems cannot

link up properly. Press the ID button for more than

ten seconds to switch between Broadcast and

Unicast mode. When the green LED is on it means

the system is in Unicast mode and when the Red

LED is lit the system is in Broadcast mode. The

default mode for this system is Unicast and it is

recommended to use this for home use. It is not

necessary to press both the Transmitter and Receiver

buttons at the same time.

②

③

④

POWER

LINK

POWER

①

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Sin comentarios

Cypress CWHDI-RX Especificaciones Pagina 11